Mobile Business Vehicles / In shop only
Mobile Command Center Repair in Yorba Linda
Command vehicles carry dense equipment loads plus a communications mast, and both need structural attention. Console mounting, mast base structure and electrical capacity are the recurring work on these builds.
A command vehicle is the most equipment dense build in this category. Consoles, displays, radios, network gear and a mast, all mounted to a body that has to keep it all in place.
All work is performed at our Yorba Linda facility. Bring the vehicle to us and we will schedule around your operating calendar as far as the work allows.
Why does the mast base need special attention?
Because a mast raised in wind puts a large bending moment into its base, and that base is mounted to a vehicle body rather than to a building. It is the same cantilevered load problem a bucket truck boom has, at smaller scale.
Mast base cracking is a recurring finding, and the correct repair reinforces into vehicle structure sized for realistic wind loading rather than reinstating the original mounting.
- Mast base mounting cracking from wind loading
- Console and equipment rack mounting fatigue
- Electrical capacity for dense equipment loads
- Roof penetration sealing at cable entries
- Generator and power system mounting
- Body and awning damage from deployment
What about electrical and generator capacity?
Frequently the limiting factor. Command builds accumulate equipment over years and the distribution rarely gets revisited, so the vehicle ends up running near capacity with connections under stress.
We assess actual load and resize distribution. Electrical and wiring work runs $350 to $9,500 and generator installation $1,500 to $12,000.
Frequently Asked Questions
My mast base has cracked.
Wind loading puts a large bending moment into a base mounted to a vehicle body. Reinforcement sized for realistic wind loading is the durable repair, not reinstating the original mounting.
Can you resize our electrical distribution?
Yes. Command builds accumulate equipment and distribution rarely gets revisited. Wiring and distribution work runs $350 to $9,500.
Do you install generators?
Yes. Generator installation runs $1,500 to $12,000 at 8 to 50 labor hours, mounted into structure sized for the load.
Do you certify communications equipment?
No. We mount, reinforce and wire distribution. Equipment certification is between you and the relevant authority or supplier.
Services We Perform on This Vehicle
Related Vehicles
We Can Help. Contact Us Today.
Bring the vehicle to our Yorba Linda facility and we will document the damage properly, work directly with your carrier, and give you a written figure built from published rates and real labor hours.
All work is performed at our Yorba Linda facility. We do not offer mobile, roadside or fleet route service.