Mobile Business Vehicles / In shop only

Mobile Pet Grooming Vehicle Repair in Yorba Linda

Grooming vehicles run water all day inside a metal box, which makes moisture the dominant failure cause. Floor and lower wall degradation, tank mounting fatigue and corrosion at every penetration are the recurring items.

A grooming vehicle is the wettest working environment of any mobile business. Water, shampoo and dog hair get everywhere, and everywhere they get, they cause problems.

All work is performed at our Yorba Linda facility. Bring the vehicle to us and we will schedule around your operating calendar as far as the work allows.

Mobile pet grooming vehicle floor being rebuilt as a continuous waterproof surface

What does the water do?

It gets into the floor at every seam and fastener, delaminating the substrate from below where nobody looks. By the time a soft spot is noticeable the area is much larger than it feels.

Then it corrodes the body at every penetration, because a grooming build has many: drains, plumbing, tank vents, electrical. Each one is a coating breach in a permanently damp environment.

  • Floor substrate delamination from persistent moisture
  • Lower wall degradation and corrosion
  • Corrosion at every plumbing and drain penetration
  • Water tank mounting fatigue from surge loading
  • Cabinetry and surface failure from moisture and chemicals
  • Electrical connector corrosion causing intermittent faults

How should a grooming interior be built?

Fully sealed and drainable, with a floor that is a continuous waterproof surface rather than a covering over a substrate, and every penetration properly detailed and sealed rather than caulked.

Tank mounting sized for surge loading, not static weight. A partly full water tank shifts hard under braking and that is what cracks mounts.

Frequently Asked Questions

My grooming vehicle floor has soft spots.

Moisture has delaminated the substrate from below, and the affected area is almost always larger than it feels. Floor repair and replacement runs $400 to $4,500 for the covering, more where the substrate is involved.

Why does my water tank mounting keep cracking?

Surge loading. A partly full tank shifts hard under braking and that dynamic load substantially exceeds the static weight the mounting was sized for.

Can the interior be rebuilt to stop the water damage?

Yes, with a continuous waterproof floor and properly detailed penetrations rather than caulked ones. Build out runs $8,500 to $60,000 and up depending on scope.

Do you service grooming equipment or the water heater?

We mount and reinforce, and we handle water heater work as part of our plumbing services at $500 to $6,500. Specialist grooming equipment service is not something we take on.

Services We Perform on This Vehicle

Related Vehicles

We Can Help. Contact Us Today.

Bring the vehicle to our Yorba Linda facility and we will document the damage properly, work directly with your carrier, and give you a written figure built from published rates and real labor hours.

All work is performed at our Yorba Linda facility. We do not offer mobile, roadside or fleet route service.

(949) 799-3387Request a Quote