Slide-Out Repair / In shop only
RV Slide Motor and Gear Repair in Yorba Linda
Slide motor and gear repair runs $450 to $4,500 at 3 to 18 labor hours. The important part is not the replacement, it is establishing why the original failed, because a motor that burned out under overload will do it again in the same conditions.
Slide motors do not usually wear out. They burn out, because something asked them for more than they could deliver. Replacing the motor answers the symptom and leaves the cause.
We measure motor draw against specification, which tells us directly whether the mechanism is asking too much.
How do you tell an overloaded motor from a failed one?
Current draw. A slide mechanism in good condition draws a predictable current through its travel. One that is binding draws considerably more, and it draws it at a specific point in travel that tells us where the bind is.
That measurement takes minutes and it is the difference between replacing a motor once and replacing it annually.
- Current draw measured through full travel
- Draw spikes located to find the binding point
- Gearbox condition assessed for tooth and bearing wear
- Controller behaviour and fault codes checked
- Wiring and connector voltage drop checked under load
- Ground path integrity verified
What about controllers and wiring?
Controllers fail, but far less often than they get blamed. What looks like a controller fault is frequently voltage drop from a corroded connector or a degraded ground, and the controller is simply reporting what it is seeing.
We check voltage under load at the motor rather than at the panel, because a connection that measures fine at rest can drop substantially when the motor pulls.
What Is Included
- 01Current draw measured through full slide travel
- 02Binding point located from draw behaviour
- 03Gearbox inspection for tooth and bearing wear
- 04Controller fault codes read where available
- 05Voltage under load measured at the motor, not the panel
- 06Ground path integrity verified
Frequently Asked Questions
How much does an RV slide motor cost to replace?
$450 to $4,500 at 3 to 18 labor hours at our posted $260 per hour mechanical and electrical rate, depending on system type and access.
My slide motor keeps failing.
It is being overloaded. We measure current draw through travel, which locates the bind, and correcting that is what stops the pattern.
Is it the controller or the motor?
Frequently neither. Voltage drop from a corroded connector or degraded ground produces symptoms that look like both. We measure at the motor under load.
Do you charge for diagnostics?
Diagnostics are $285 per hour with a one hour minimum, refundable as a credit against an authorized repair. On a recurring motor failure it is the most useful hour you will spend.
Vehicles We Perform This On
Related Services
We Can Help. Contact Us Today.
Bring the vehicle to our Yorba Linda facility and we will document the damage properly, work directly with your carrier, and give you a written figure built from published rates and real labor hours.
All work is performed at our Yorba Linda facility. We do not offer mobile, roadside or fleet route service.