Vans and Camper Vans / In shop only
Cargo Van Repair in Yorba Linda
Cargo vans accumulate low speed damage constantly and need fit out work as often as body work. Sliding doors, rear barn doors, bulkheads, shelving and floor liners all take daily abuse in a way a passenger vehicle never does.
A working cargo van does not usually have one big accident. It has a hundred small contacts a year, and after four years the cumulative effect is worse than most single collisions.
The other half of cargo van work is fit out: shelving, bulkheads, liners and the mounting that keeps them attached under braking.
What wears out on a working cargo van?
Doors first. Sliding door tracks, rollers and latches see hundreds of cycles a week, and rear barn door hinges and latches take the same. Both are repairable rather than replaceable in most cases.
Then the load area. Floor liners wear through, shelving mounting elongates its holes, and the lower body panels take contact from loading. None of it is dramatic and all of it accumulates.
- Sliding door track, roller and latch from high cycle use
- Rear barn door hinge and latch wear
- Cargo floor and liner wear through
- Shelving mounting hole elongation
- Lower panel and rocker damage from loading
- Bulkhead mounting fatigue
How should shelving be mounted?
Into structure, not into panel. This is the most common fit out failure we correct. Shelving bolted through a side panel holds fine standing still and fails under braking, and when it fails it takes the panel with it.
Correct mounting finds the structural members and attaches to them, with load spread rather than concentrated. Cargo shelving and racking installation runs $750 to $7,500 at 4 to 30 labor hours, and most of that labor is finding and preparing real attachment points.
Frequently Asked Questions
How much does cargo van shelving installation cost?
$750 to $7,500 at 4 to 30 labor hours depending on the system. Most of the labor is locating and preparing structural attachment points rather than assembling the shelving.
Can you repair a sliding door rather than replace it?
Usually yes. Track, roller, latch and power mechanism repair runs $400 to $3,500 at 2 to 14 hours, which is well below replacement on most vans.
Do you install bulkheads and partitions?
Yes. Bulkhead and partition installation runs $400 to $2,500 at 2 to 10 labor hours.
Is accumulated minor damage worth repairing?
On a vehicle you intend to keep or resell, usually yes, and it is cheaper as one planned job than as six separate visits.
Services We Perform on This Vehicle
Related Vehicles
We Can Help. Contact Us Today.
Bring the vehicle to our Yorba Linda facility and we will document the damage properly, work directly with your carrier, and give you a written figure built from published rates and real labor hours.
All work is performed at our Yorba Linda facility. We do not offer mobile, roadside or fleet route service.